Lose je objasnjeno.
Description:
The USB wireless device, PC is recognized as the serial device (please install our Serial Driver)
Sending end can easily set the baud rate, in order to prevent the receiver-side processing, however, the sender sends a packet preferably every 5 ms delay
Just need an AT command, such as AT + SET = 40270102030405
Instructions explain: 40 representatives 0X40 refers to the physical frequency number, based on the increase in 2400MHZ can set a total of 126 0X40MHZ
27 representatives SETUP register used to set the baud rate transmit power and receive
0102030405 physical address on behalf of five software
Modules when no data is sent automatically enters the receiving state
The module operates in a dynamic packet format.
Link: [url=https://www.dropbox.com/s/0ngkcrkyfw7iq79/USB_2.4G_CODE.zip]https://www.dropbox.com/s/0ngkcrkyfw7iq79/USB_2.4G_CODE.zip[/url]
Da li je neko zna kako se ovo koristi?
Treba li sta da se konfigurise?
Ovaj kod sto moze da se skine za 8051, pokusao sam da prepravim za pic, ali nije proradila veza..
Pozdrav!